Product Details

XLR Through Barrel

$7.00

Product Description

This is a 'barrel' style connector with one 3 pin XLR male at one end and a 3 pin XLR female at the other end. The top picture shows the components, the bottom picture shows the assembled connector. There is not enough length here to put a transformer in the barrel, but a pad will fit fine. Or you can drill a hole in the barrel and add a cable for a 'pigtail' like our xlr pigtail listed in the adapters section of the site.

It comes with a pair of wires pre-installed, and with pin 1 shorted to the case. You should remove this shorted wire, as it will create ground loop and 'pin 1' problems. If you need a ground, then wire it yourself with another wire.

Product Code: xlrthru

 

Copyright 2015 A2Stuff.com

Mobile Site

eCommerce by CubeCart